LumberJocks

DMT DiaSharp Diamond Plate Sharpening Station

  • Advertise with us
Project by uMinded posted 02-04-2015 06:22 PM 1370 views 0 times favorited 0 comments Add to Favorites Watch

This is my DMT DiaSharp diamond plate sharpening station. I have:

3” x 8” DiaSharp® Stone, 220x
3” x 8” DiaSharp® Stone, 600x
3” x 8” DiaSharp® Stone, 1200x
3” x 8” 1/8” Leather with honing compound

I made it out of a scrap piece of 1” x 12” pine shelving I had left over and some Fir strips from a dovetail practice board. I planed the pine down until it was nice and flat then planed down the 1” Fir strips until they where a bit thinner than the diamond plates. I arranged everything, applied glue and some weights and left it over night. After trimming and squaring everything up I rubbed on some beeswax and oil and sealed it with three coats of aerosol lacquer.

Stones are a snug fit, not attached and the leather is just double sided taped into place.





0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com