Project Information
I needed a solution for my spindle sander as I am way too short to operate this thing on my workbench.
Picked up some cheap lumber at the BORG and tried my hand at mortise and tenon joinery. I hogged out the majority of the mortises on the drill press and finished with a chisel. After a dozen or so I felt pretty confident though the chip-out in this lumber was significant. I left the plywood panels unattached. The bottom one isn't going anywhere and the top one removes so the sander can sit lower to slide under my table saw.
Picked up some cheap lumber at the BORG and tried my hand at mortise and tenon joinery. I hogged out the majority of the mortises on the drill press and finished with a chisel. After a dozen or so I felt pretty confident though the chip-out in this lumber was significant. I left the plywood panels unattached. The bottom one isn't going anywhere and the top one removes so the sander can sit lower to slide under my table saw.