|Project by Sawdustmaker115||posted 10-18-2014 06:16 PM||2181 views||7 times favorited||16 comments|
This keep safe box is made out of some #2 white pine that I planed down to 1/2’’ thick.
I made a raised panel for the lid, this was done on the Table saw with the blade beveled to about 20 degrees. The Draws were made with simple tongue and groove joints and the bottom piece is set into rabbit. They were stained with a golden oak stain and lacquered, then I lined the bottom with black felt. The Draw fronts were made in the same manor as the top and stained with english chestnut stain, then lacquered. I cut out the mortises for the hing by hand with a chisel and a small router plane. I lined the top compartment with black felt on all surfaces. The carcase of the box I stained with english chestnut, the frame that wraps around the box was stained with a golden oak stain and sprayed with four coats of lacquer.
Thanks so much for looking!
Any and all comments are welcome.