|Project by GenuineGeek||posted 09-25-2014 02:12 AM||1356 views||5 times favorited||4 comments|
I had the back board piece left over as scrap from another job, it’s aboubt 16 inches long and 3.5 inches wide.
I turned a bottom and the top and then cut a bit off on the table saw and glued and screwed it together.
It sits fine when leaned against a wall but really needs either a way to attach it to the wall or a larger base to sit well on its own.
The way it works is that the rolling pin is inserted from the bottom into the top hole and then set down on the base. Reverse to take out.
-- Don't try to figure it out... just turn it.