LumberJocks

Alignment jig

  • Advertise with us
Project by Matt posted 08-21-2014 05:43 PM 2014 views 10 times favorited 3 comments Add to Favorites Watch

I’ve been getting’ jiggy so to speak. Cross cut sled, ripping sled, and now this alignment jig.

I got a little (very little) creative by cutting slots in the ends of the track and inserting some screws into the slot end wise to splay the ends and tighten the fit in the slot. Works pretty well.

-- I do this for fun.





3 comments so far

View Matt's profile

Matt

182 posts in 883 days


#1 posted 08-21-2014 05:46 PM

Btw, my measured blade wobble is only .005”. Not too bad.

-- I do this for fun.

View Matt's profile

Matt

182 posts in 883 days


#2 posted 08-21-2014 06:04 PM

Everyone needs one of these! Zero guess work setting up the blade or guide! Even if you are in the camp of “it doesn’t need to be that tight” it sure is easy and will be simple to certify in the future!

-- I do this for fun.

View Mahini's profile

Mahini

20 posts in 807 days


#3 posted 11-02-2014 02:51 PM

I’m thinking of buying one of these instruments. Before hand I’m worried if motor and the shaft-Pluse-Blade would be off then what I can do ? You see my table saw was worth 300$ by the Chinese ?

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com