LumberJocks

Brick pattern cutting board

  • Advertise with us
Project by ChrisB33 posted 08-09-2014 07:56 PM 1007 views 2 times favorited 3 comments Add to Favorites Watch

I’ve been looking at several cutting boards over the past couple of months trying to decide which one to build for my wife. I really liked the brick pattern cutting boards that others had built and figured I could learn a lot in constructing one. I had some extra maple and padauk laying around so I thought I would give it a shot. In the process I built a small crosscut sled for my tablesaw which made the construction go a lot quicker. I sanded the whole board with 220 grit sandpaper and put a 1/8” round over on all the sides. Finished it with three coats of butcher block oil. For a newbie I thought it turned out pretty well.





3 comments so far

View Mr M's Woodshop's profile

Mr M's Woodshop

394 posts in 2532 days


#1 posted 08-09-2014 09:06 PM

Welcome to LumberJocks, and welcome to the cutting board club!

Nice looking board. It looks like it’s endgrain … or is the “horizontal” mortar edge grain? How long were the pieces you used for the horizontal mortar? I’m curious how that fit into your design.

-- Henry Mowry, Santa Clarita, CA, http://www.MowryJournal.com

View hotncold's profile

hotncold

762 posts in 1009 days


#2 posted 08-09-2014 09:08 PM

Nice job! Welcome to LumberJocks!

-- Dennie - Tennessee

View MrNorwood's profile

MrNorwood

180 posts in 1177 days


#3 posted 08-11-2014 09:43 PM

looks good

-- Remember, Jesus was a carpenter.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com