LumberJocks

Table saw extensions

  • Advertise with us
Project by Ajs73 posted 06-18-2014 01:08 AM 1738 views 2 times favorited 7 comments Add to Favorites Watch

Added wings to my old craftsman
left tilt (King Seely) tablesaw 103.22160. On the right side I used my little
router table framed out with 1” oak
to make up the difference. The left
Is just two pieces of 3/4” oak
glued together. Tabletop went from 17”x 20” to
40”x 20”. I will probably add an out feed
extension at some point The last picture is my attempt at
dust collection. I covered the whole
bottom with plexiglass with a roofing
boot attached.


-- Andy, Alliance,Ohio





7 comments so far

View Tim Royal 's profile

Tim Royal

203 posts in 951 days


#1 posted 06-18-2014 05:05 AM

Looks like you have my saw! I think your original dimensions were 27×20 and should now be 27×40 unless you don’t have a classic 113 as I do. Where did you get the fence? Definitely an improvement over factory all the way around!! Thanks for the post.

-- -Tim Royal... Always reminded of this when I see the amazing work LJ's do (I have no choice but to be humble!), "Pride makes us artificial and humility makes us real." -Thomas Merton

View Ajs73's profile

Ajs73

134 posts in 982 days


#2 posted 06-18-2014 08:34 AM

Original table size is 17” x20”. That is correct
Also as stated above it a 103 not a 113.
Fence came on saw. Bought on CL for $50 It’s pretty neat that one knob operates height
and tilt

-- Andy, Alliance,Ohio

View Tim Royal 's profile

Tim Royal

203 posts in 951 days


#3 posted 06-18-2014 11:54 AM

Ahhh, yours is a couple years older then … missed that. I have an early Emerson 113… Pretty saw and very useful now! Clever use of router table.

-- -Tim Royal... Always reminded of this when I see the amazing work LJ's do (I have no choice but to be humble!), "Pride makes us artificial and humility makes us real." -Thomas Merton

View Ajs73's profile

Ajs73

134 posts in 982 days


#4 posted 06-18-2014 12:12 PM

Thanks, I’d like to come up with a way to use motor to run something
else out the back ( motor has duel shaft ) but needs to be something
that can run with motor running in reverse. Anyone with ideas ?

-- Andy, Alliance,Ohio

View Fishinbo's profile

Fishinbo

11362 posts in 1640 days


#5 posted 06-19-2014 07:55 PM

Nice set up there!I like the new wings. Your table saw now become more versatile.That should make a difference .

View Ajs73's profile

Ajs73

134 posts in 982 days


#6 posted 06-20-2014 11:30 PM

Added out feed extension. Only 12” or so but good for me !
34” x 40” is like another workbench !


-- Andy, Alliance,Ohio

View Ajs73's profile

Ajs73

134 posts in 982 days


#7 posted 06-20-2014 11:40 PM

Also found a use for my leftover HF DC
parts ( stand/ bracket ) & brackets from radial
arm saw recall, very stable with the
cast table and oak extensions.

-- Andy, Alliance,Ohio

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com