LumberJocks

End Grain Cutting Board

  • Advertise with us
Project by mrussell441 posted 86 days ago 414 views 0 times favorited 1 comment Add to Favorites Watch

I started off by cutting 20 inch strips of walnut, cherry, oak, and maple into various widths. Then I glued all of the strips together and clamped them. After the glue dried I took it out of the clamps and ran both sides through the planer until they were flat. Then I cross cut the board into strips and turned them on end, and flipped every other one , then I glued the strips together. When all the glueing was done, I belt sanded it until it was flat. I then hand sanded it with 220 grit paper. For the finish, I applied many coats of mineral oil. The last thing I did was drill pilot holes and screw on rubber feet. Thanks for looking!





1 comment so far

View Rick's profile

Rick

6455 posts in 1638 days


#1 posted 86 days ago

Very Nice Work Indeed! Thanks For Posting.

-- COMMON SENSE Is Like Deodorant. The People Who need It Most, Never Use It.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase