I am starting a new side table, three legged, with a round top. QUESTION: I want to make the bottom a hexagon. I also have to make a jig to route out the slots while the piece is still in mt lathe to utilize the index, anyone have any ideas??? I know I can set my saw to 30 degrees to make the cuts, but a little stuck there.
|This blog is written by pete57 | 4 entries so far|
I bought a new Jet VS 1220 with the extension and built a nice stand. The machine itself is not v...
help!!!I have not been on the site for a while, please for give me. I am trying to get all these ...
I built a home about 4 years ago and went with just enough to get Certificate of Occupancy. I hav...