| This blog is written by nakamaruchi | 11 entries so far |
-
Shop Notes #5: 4 months
It is four months since I worked in my shop.I have been very very busy for these four months so t...
-
Getting a tablesaw #6: Cutting Unifence and Wixey Digital Read Out
In accordance with Gary’s advice I asked Wixey if we could cut sensor strip of Wixey 700. T...
-
Getting a tablesaw #5: Finally I got a table saw.
After long thinking I decided to buy a new table saw instead of looking for how to buy festool op...
-
Getting a tablesaw #4: There must be a lot of trouble in using Festool
Thanks to much advice from kind people in LumberJacks but I must give up useing Festool in Japan....
-
Getting a tablesaw #3: Wire Transfer
I found a retailer which can send us Festool items. I thought I could get Festools again finally...
-
Shop Notes #4: Loft
Small shop has no space except for ….. upwise ! So I made loft-like storage. ...
-
Getting a tablesaw #2: Getting a Festool Multifunction table
Before a lot of people advised me not to buy a new tablesaw for my small shop.So I changed my min...
-
Shop Notes #3: Shop improvement and Dust Collection of my bandsaw
These several days I have been into improving my small shop. I made a shelf which is like a loft....
-
Shop Notes #2: Spiral bit --Collet loosening
I tried as Gary and Todd said this morning. I put it in all the way and then back it out just a ...
-
Shop Notes #1: Making drawers and Bit Loosening
I made drawers of my router table. It was very hard for me to duplicate many parts. That’s ...
-
Getting a tablesaw #1: At the begining
I have Festool TS55 circular saw, because my shop is too small to place a tablesaw which will occ...
