LumberJocks

Crochet Box #2: Raised Panel

  • Advertise with us
Blog entry by mpmitche posted 10-22-2011 05:15 AM 736 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 1: Glued up! Part 2 of Crochet Box series Part 3: Finished »

Tonight I spent some time working on the raised panel lid for the box I have been working on. All the work was done with a block rabbate plane. I started out cutting a wide rabbate on the ends of the panel about 1/8 inch deep and then the sides. This was followed by cutting a slope that hit my scribe line on the outside of the pannel and the bottom of the existing rabbate at the same time. Again I started with the cross grain cuts and then finished with the with grain sides. I tried scrapping the cross grain work with a card scrapper but finally had to break down and use sandpaper to get the finish the way I wanted it.

Next I finished trimming the panel to fit the opening in the box.

Now for some hinges and a finish on the outside and it will be done!

-- Mike, Western New York



1 comment so far

View mafe's profile

mafe

9509 posts in 1740 days


#1 posted 10-22-2011 01:14 PM

It is a beauty.
Best thoughts,
Mads

-- Mad F, the fanatical rhykenologist and vintage architect. Democraticwoodworking.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase