LumberJocks

Tree brach lamps question

  • Advertise with us
Blog entry by Monte Pittman posted 850 days ago 3136 reads 0 times favorited 3 comments Add to Favorites Watch

It has probably been posted before, but it was wondering how to run an electric cord through a crooked branch to make a lamp. Any instructors out there?

-- Mother Nature created it, I just assemble it. - It's not ability that we often lack, but the patience to use our ability



3 comments so far

View gagewestern's profile

gagewestern

300 posts in 1977 days


#1 posted 850 days ago

i dril as far as i can one direction comeing out at a direction change then dril what ever way the branck goes and so on until you reach the other end . then thread the wire through and fil the holes after you are done

-- gagewestern

View stan3443's profile

stan3443

199 posts in 902 days


#2 posted 850 days ago

depending on how croked bandsaw it in half run a corebox bit down both sides glue it back tokether

-- If your not supposed to have hair on your face......why does it grow their

View gfadvm's profile

gfadvm

10724 posts in 1317 days


#3 posted 850 days ago

If I had this to do I would try Stan’s method but it may be challenging guiding the router bit down the center. A trim router would probably be best.

-- " I'll try to be nicer, if you'll try to be smarter" gfadvm

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase