|Workshop by map||posted 10-19-2008 12:10 AM||1007 reads||0 times favorited||2 comments|
My shop is ~14’ x 20’ and located in my basement. The three interior walls are covered with 1/2” plywood to allow fastening “stuff” to the wall. As you can probably see, I have way too much “stuff”.
The table saw is a 1980s vintage “electronic” contractors saw. I have a router table attached to one side and the saw is attached to a bench that also serves as a cutoff table. The whole thing becomes my assembly area. This requires careful planning to avoid having to clear everythiing off to make another cut before proceeding. I don’t think that I have ever actually managed to do this.
The slabs in the first picture are the drawer fronts (or will be) and the boxes on the second pict are the drawers for the file cabinet that I am currently working on.
The bench in the last picture is new. I replaced an older and larger bench with this one so that I could bring my tool boxes in out of the garage.
-- measure once, cut once, swear, start over