Can any of you brilliant, engineering types help a dumb, little old lady with TS V-belt questions?
I recently replaced the 5-HP motor on my Grizzly right-tilt table saw. (To be honest, my husband did because this weakling couldn’t lift 65 pounds.) I figured it was a good idea to replace the belts, too, so I ordered a set from Grizzly along with the motor. I’ve now gotten 3 sets of belts from Grizzly and none of them match my old, original belts. My original belts were FM-26. The first belts sent were 3V-250 which were the same configuration but too short. When I called back, I was sent 3L-270 which were not as deep and were longer but fit on the pulley and could be tensioned adequately. I called to ask if they could be used successfully even though longer and not as...
