or Join Now!
how can I keep the blade on my grizzly g1022sm from lowering itself while I am trying to make a cut?
home | projects | blog
5 posts in 2500 days
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
1025 posts in 2994 days
#1 posted 03-19-2010 03:06 AM
there should be a locking knob on handwheel. if you don’t have a manual here’s the link:
if that doesn’t work, call grizzly, you may have a defective part.
-- Better woodworking through old hand tools.
#2 posted 03-19-2010 03:41 AM
it looks like if I take the roll pin out of the end of the worm shaft behind the handwheel and add a couple of washers it would take the play out, but I am afraid the roll pin will not go back in
#3 posted 03-19-2010 04:17 AM
there should be no play, however sounds like you bought it used, and there may be some wear. i’d be surprised if that much wear occurred with normal use. i recommend calling grizzly before you launch into taking it apart. they are very friendly and phone calls don’t cost much these days ;)
#4 posted 03-19-2010 04:42 AM
thank you for your adviceI cannot find the phone number on their website
#5 posted 03-19-2010 04:44 AM
found itI sent an email and I will try to work with their customer servicethanks again!
#6 posted 03-19-2010 05:55 AM
One of these should work:
For Customer Service and Technical Support:Customer Service: 1-800-523-4777 Technical Support: 1-570-546-9663 Fax: 1-800-438-5901 Email: Customer Service: email@example.comTechnical Service: firstname.lastname@example.org Foreign Orders: 1-360-647-0801 / Fax: 1-360-671-8375 Canadian Orders: 1-800-523-4777
Go to Pulse page »
©2017 Verticalscope Inc. All Rights Reserved. |
Terms of Service
DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.
Latest Projects |
Latest Blog Entries |
Latest Forum Topics