In this episode I start working on a chest. I cut all the parts to the right width on the tablesaw then I cut all the parts to the right length on the miter saw.
-- kosta Virginia Beach, VA http://www.kostasworkshop.blogspot.com/
| Blog entry by kosta | posted 1168 days ago | 787 reads | 0 times favorited | 2 comments |  |
 |
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
2 comments so far
furnitologist
home | projects | blog
198 posts in 2210 days
#1 posted 1165 days ago
Hey Kosta…................I see the router table. Haven’t looked, but I got a newsletter from woodsmith about turning routre table into a edge jointer…....do you get that e-letter? If so did you see it??
N
kosta
home | projects | blog
946 posts in 1552 days
#2 posted 1165 days ago
Yea I did actually I tried that with a flush trim bit I used hardboard and it didnt work out right because the hardboard is too thick. I am going to get plastic laminate.
-- kosta Virginia Beach, VA http://www.kostasworkshop.blogspot.com/
Have your say...