Need ideas for a feed table

I was thinking about making one of these.

http://www.ptreeusa.com/tablesaw_products.htm#16ext

-- http://theinquisitivewoodworker.com/

not nowing how much space your dealing with i would offer you this i made my assembly table into my out feed but i have a cabnet saw so theirs no moter coming off the back dont know if that will help i also have a large shop so sorry if im of no help what so ever

-- I buy tools so i can make more money,so ican buy more tools so I can work more, to make more money, so I can buy more tool, so I can work more

I saw an out feed “table” that was a large wood cylinder that rolled when you ran a board over it. Grooves were cut out for the miter gauge slots. It could set behind the saw and only take up a 8” space or be set back 8’ to cut long boards.

I’m in the middle of building a folding outfeed table I saw in an issue of Woodsmith. I have it but there is no number on it . They sent it to to get me to suscribe. It uses folding shelf brackets to support a laminate topped table with miter slots in it. It looks pretty good and will fit between my saw and my new work bench whichis the same height as the saw.

-- Thos. Angle, Jordan Valley, Oregon

Thank everybody got some good ideas I will see what I can do. Mike I like the idea that you sent it will definitely save room. I might add the wood cylinder roller idea that you sent Dennis, again thank a lot everybody.

-- Jeff B.