or Join Now!
Hi,Before spending a bunch of money on a scroll saw, I’d like to try & use the ole Delta 40-100 of my father-in-laws.
I’m told it uses 6” blades, does anyone know where I can get some?
home | projects | blog
7 posts in 2960 days
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
123 posts in 3026 days
#1 posted 03-25-2008 10:51 PM
sorry don’t know where you can buy them but don’t forget the coping saw and the fret saw
-- A. Molloy
93 posts in 2991 days
#2 posted 03-26-2008 12:01 AM
pinned end? if clamp end grind off pins from coping saw blades.
-- Pretzel L8agn
10262 posts in 3234 days
#3 posted 03-26-2008 12:24 AM
-- Gary - Never pass up the opportunity to make a mistake look like you planned it that way - Tyler, TX
#4 posted 03-26-2008 03:04 AM
Near as I can tell, it’s a plain end, tried putting a pin-end in it, no place for the pin to go.
I’ll try the coping saw blades…
Thnx ur help.BRgds,Knot
#5 posted 03-26-2008 03:21 AM
If you get pins end blades you can knock out the pins.
#6 posted 03-26-2008 03:56 AM
Rite, did that w/the 5” blades, just before I broke ‘em!Hopefully the 6” ones will work, thnx for the tip.
#7 posted 03-26-2008 04:02 AM
Gary, thnx for the Amazon tip, I’d have never thot of lookin’ for ‘em there!
1467 posts in 3333 days
#8 posted 03-26-2008 05:05 AM
I googled 6” scroll saw blades
Most are 5” but these folks have 6” plain end.
I did not check all hits, either
-- No piece is cut too short. It was meant for a smaller project.
#9 posted 03-26-2008 06:42 AM
Thanks for the tip.BRgds,Knot
Go to Pulse page »
©2016 Verticalscope Inc. All Rights Reserved. |
Terms of Service
DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.
Latest Projects |
Latest Blog Entries |
Latest Forum Topics