LumberJocks Woodworking Forum banner

Workshop Information

Location
New Zealand
Wood shop, is a converted CKD car transport crate,extended the roof up with 2×3 and translucent shower panels from recycle shop,the roof ,is two tilta door garage doors with a box of silicone tubes to fill the gaps !The silicone was a $2 box lot from TradeMe all different colours and 1/2 of them rock solid /unusable(rip).
...Just recently arranged ,proper switched power 10amp ,before then had illegal over head extension cord 10 mtrs from house to shed. The voltage drop was burning out the starter on my bandsaw.all fixed now.
..Alas the B@ decker saw ,needed new bearings for the circular saw ,saw has been lurking under the Triton Saw Bench,outside for the last 7 seven years. 3 x Bearings ,were expensive but definatley cheaper than a new 10 "inch saw.
..There is a v twin compressor under one of the benches plus some staple and brad nail guns mainly used for craft work ,plus a cheepo big box Nail Gun for 90mm and 65 mm nails wire twist for construction.
....Project on bench,slowly as I aquire parts/bits is a Router copier/duplicater plans from sales@woodgears.ca

Gallery

Comments

· In Loving Memory
Joined
·
1,963 Posts
At least you wont be overcome by paint fumes. After 23 inches of snow crushed my old shop that is what mine looked like for a while. Insurance paid about half enough to replace it. One step forward and two steps back as usual. By the way your patio roof has a small leak.
 

· Registered
Joined
·
4 Posts
Mudflap4869 i like your Wringer Machine and the Saw book case ,but the tomahawk cane is the bees knees ! Well done, may i make one like ? My father in law, whittles walking canes out of Beech with a pocket knife but i prefer the tools option !
 

· Registered
Joined
·
4,326 Posts
I hope you didnt toss the silicone, as you could cut it into pucks and fit to the feet of your gear to reduce noise/vibrations
 
Top