Blog series by jusfine | updated 12-21-2010 07:31 PM | 2 parts | 28554 reads | 11 comments total |
Part 1: Concept and Casework, Shelves
I saw this in an older Fine Woodworking issue (#202) and was compelled to finish my outfeed table for my Unisaw. Mine needs to be built a little different as I have the sliding table to the left of my saw, and the left extension wing is removed. My storage below the table will really only have only one usable side and end. I designed it to be 90 degrees from the photo, two drawers at the bottom, table saw blade storage, and an open spot for my dado blade kits on the higher level. I ...
Part 2: Taking way to long to complete this simple project...
I finally got some time back in the shop. I calculated the size of the outfeed table, had a friend with a cold press laminate both sides of a sheet of MDF for me, I cut it roughly to size and set it aside to finish up the base cabinet. I lost some photos somewhere for the middle of this process, but once my blade storage shelves were sanded out, I turned some purpleheart center dowels on the lathe for the blades to sit on. I made two sizes, one for the 10” blades, and one for the...