dataman's Workshop

I like it- but then, I like anything with rounded edges- and yours are very rounded. Your shop looks to be well outfitted. You have an enviable table saw with excellent storage underneath. I can also envy your Performax sander. I could use one, though I’ve always had trouble getting the sandpaper on right. As long as I keep to ve been making a holder for some palm carving gouges using just the band saw for all the cutting. Half-lap joints are so easy on the band saw.

-- "So much wood. . .so little time!"

You are not alone with trouble installing the sandpaper on the Performax. I have gotten so desperate (last piece) that I have used duct tape on the inside to hold it in place. It works but you must remember not to run your board over too far!

Great looking domes.

-- Jesus is Lord!

Very interesting nice space utilization…

-- Sawhorse - Sulphur Springs, TX - www.sawhorseworkshop.com

fascinating!!
I was wondering about the lack of corners. I’d probably be shoving junk behind shelves, never to find the stuff again..

-- "Functional WoodArt" by Debbie, Canada (http://www.execulink.com/~yohan)

Not having corners is or can be an advantage!
I took advantage of the curved walls with shelves that do not take up usable floor space. Let me explain – if I stand next to the wall with my sholder against it I have well over a foot of floof space from my foot to the wall. By building a 4’ wide shelf unit that conforms to the wall I have losts of storage space.
(Side view of storage shelves)!
I leave the floor area open so I can stuff 5 gal buckets under it and I can get almost 2 buckets under the shelves one in front of the other. I find that writing the contents on the buckets helps me find stuff again. the real trick is that each shelf is deeper in the center of the unit as it folows the wall around so its a little tricky to build but stores a lot of stuff!!

ah!! I saw “seeing’ a rectangle shelf. Brilliant.

-- "Functional WoodArt" by Debbie, Canada (http://www.execulink.com/~yohan)

Nice shop dataman. I can see some advantages in having a rounded shop instead of one with corners. I like the natural light and the high ceilings too. I love that table saw and bench combination.

How is the temperature in your shop? Cooler or hotter than normal?

-- Bill, Turlock California, http://www.brookswoodworks.com

Great Shop dataman. I see that you’ve got all your corners covered. Er. bases covered!

-- Karson Southern Delaware karson_morrison@bigfoot.com

The shop temp is usually very comfortable! The dome shell is highly insulated on the outside with polyurethane foam and is equivalent to about an R65 or better and it goes from below grade covering the entire exterior surface with no breaks. Normal (stick) construction uses R13 and if one where able to slide all the studs to one side of your wall 1/4 of the wall wouldn’t even be insulated. Sorry! I will get off my soapbox (can you tell I am a fan of these incredible structures?).

I did heat the shop (radiant in floor) so I keep it around 60 in the winter. The tallest part of the dome is 14’! I can easily take an 8 or 10’ piece of material and turn it over without hitting things – that’s so cool!

All the windows do open so I take advantage of the summer breezes.

Hi Dataman,

You certainly have one of the more uniquely designed shops that I have seen. The headroom that you have is wonderful. You also have a nice set of tools to work with as well. I would enjoy working in there.

Thanks for the post.

-- With God's help all things are possible- even woodworking. Woodworking is not just a hobby, it is an (expletive deleted) expensive hobby.