| View dataman's: | home | workshop | projects (11) | blog (2) | reviews (4) | forum topics (0) | buddies (0) | favorites (0) | activity log |
Makita LS1013 10-Inch Dual Bevel Sliding Compound Miter
Technical Details10-inch dual bevel sliding compound miter saw kit with laser; 15 amp motor Cuts 52 degrees right and 45 degrees left with 9 positive stops at 15, 22-1/2, 30, 45 degrees left or right and 0 degrees Machined aluminum base; dual steel rails; carbide tip blade Includes saw, vertical vise, blade, wrench, triangular rule, 2 extension wings 29-1/8 by 20-1/2 by 25-1/4 inches; 48-1/2 pounds; 1-year warranty The saw carriage slides on two precision-ground steel rails that are fitted...
Hitachi M12V, 3 ¼ Hp, Plunge Router
I have two of these routers!I mounted on in my router table and use the other one for manual jobs. Having a 3 ¼ Hp, 15 AMP motor, the Hitachi M12V is can handle virtually any routing job or bit design. The motor features an infinitely adjustable electronic speed control dial and soft start to make it manageable for hand use. The 8,000 to 20,000 rpm range (no load) dial is divided by 1 through 5 numerals (no detents) on the dial. The On/Off switch is located off the right-side handle and...
Dewalt DW735
I have really worked this tool for many hours lately and am totally impressed with its performance. It is pricy but has received a number of best product recognitions in magazine articles in their plainer reviews. It’s easy to adjust and feed wood through. You must use a vacuum system with it! It’s 13” wide capacity should cover most boards you want to plain down.It has a three knife cutter-head which helps extend the life of the knife. The blades are easy to change and t...
3D Router Carver System by CMT
Quite a few years ago I purchased a CMT 3D Router Carver System by CMT.My first project was the front of a cedar chest I built for my oldest son as a wedding gift. It allowed me add a professional looking carving on the front of the chest without screwing it up since I do not know how to carve. I have had this tool for at least 10 years and for a while it went out of production but a couple of years ago they reintroduced it. It is easy to set up and as long as you have a ½” plunge rout...
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
