| Blog series by Bob #2 consisting of 1 part so far |
Part 1: Another method for making this handy tool
After seeing the neat job that MOT/ Tom did with his shooting board I was enticed to make one of my own.I am in the middle of milling some wood for small boxes so I will needed something to handle these small gauge materials.I am a pack rat and wood hoarder by genetic make up so when I dug through one of my precious piles of scrap I found an old poplar plywood shelf, a piece of arborite (Tom’s idea) and a piece of 3/4” fir flooring plywood.The rest were off cuts of oak walnut etc ...
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
Blog Series
- A new shop in the making - 15 parts
- An easy project the shows some tool uses. - 1 part
- Attempts at relief carving - 1 part
- Making a few tools for the wood lathe - 5 parts
- My Shooting Board - 1 part
- My shop tour 2007 - 1 part
- Passing it on - 1 part
- Passing over the tools - 0 parts
- Passnig it on - 0 parts
- Pimping out an imported plane - 1 part
- The Great 2008 2 x 4 challenge ! - 1 part
- Urban wood to lathe turnings - 2 parts
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
