| Blog series by Bob #2 consisting of 1 part so far |
Part 1: bathroom 2 x 4 vanity shelf
I’m not going to beat about the bushes with this utility bathroom shelf.It is what it is, a shelf made from a 2×4. I made it from a 2×4 ( spruce). The top and shelves are 7” wide and 12” long.The unit stands 25” tall.The 2×4 was sliced in half and the boards jointed to make the shelves.The four legs are 2” tapering down to 1-1/4”. Each section of the leg has two dowels placed to pin it to the shelves, the legs had to be cut in opposite di...
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
Blog Series
- A new shop in the making - 15 parts
- An easy project the shows some tool uses. - 1 part
- Attempts at relief carving - 1 part
- Making a few tools for the wood lathe - 5 parts
- My Shooting Board - 1 part
- My shop tour 2007 - 1 part
- Passing it on - 1 part
- Passing over the tools - 0 parts
- Passnig it on - 0 parts
- Pimping out an imported plane - 1 part
- The Great 2008 2 x 4 challenge ! - 1 part
- Urban wood to lathe turnings - 2 parts
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
