| Blog series by Bob #2 consisting of 1 part so far |
Part 1: A trial carving in Box Elder Trial #1
I was bored and out of mojo yesterday so I grabbed this piece of stump and relief carved out this ornamental flower on the face with a pattern and a 1/4 ” spiral bit in a hand router.I then fiddled around with a carver set and scooped out the petals a bit.Sometimes it’s good to try something you have no clue about.I’m going to paint the flower and set the stump out among the flowers in spring. p.s. you can see where I ploughed right through the bark in a couple of places....
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
Blog Series
- A new shop in the making - 15 parts
- An easy project the shows some tool uses. - 1 part
- Attempts at relief carving - 1 part
- Making a few tools for the wood lathe - 5 parts
- My Shooting Board - 1 part
- My shop tour 2007 - 1 part
- Passing it on - 1 part
- Passing over the tools - 0 parts
- Passnig it on - 0 parts
- Pimping out an imported plane - 1 part
- The Great 2008 2 x 4 challenge ! - 1 part
- Urban wood to lathe turnings - 2 parts
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
