| Blog series by Lee A. Jesberger | updated 68 days ago | 1 part | 186 reads | 26 comments total |
Part 1: A router table for use with Incra Accessoriess
I guess about ten years ago I made a second router table for certain applications. Mostly it was to be used with Incra jigs and accessories. This table is a little fancier than the last one I posted ands does have a few advantages. For example there is no back to this cabinet. Both sides have the same door arrangement, so accessing the router is easier to make height adjustments. Also there is a lot of bit storage in the four vertical pull outs. These too can be pulled out to either ...
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
Blog Series
- Advice on Patents - 1 part
- Burls - 1 part
- Conference table / work bench - 2 parts
- Custom Desk - 1 part
- Custom Floor - 1 part
- Demilune table tops - 2 parts
- Elevator Door? - 1 part
- Fine Woodworking & Ezee-Feed Review - 1 part
- Fine Woodworking does ezee-feed review - 2 parts
- Fireplace Mantle - 1 part
- General Posts - non woodworking - 1 part
- Homemade Tools - 3 parts
- Jigs - 2 parts
- Living Room and Bar Project - 1 part
- Marquetry - 1 part
- One year already? - 1 part
- Our Shop - 1 part
- Pizza Ovens - 0 parts
- Proud of my Buddy - 1 part
- Router Table - 1 part
- Router Table Fence - 1 part
- Shop Featured on Delta |PorterCable - 2 parts
- Shop Safety - 3 parts
- Techniques - 1 part
- Vacuum series - 1 part
- Veneering - 3 parts
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
