| Blog series by Lee A. Jesberger | updated 184 days ago | 3 parts | 949 reads | 58 comments total |
Part 1: A Primer Course
Veneering, a Primer Course The top photo is a couple sample packs of sequenced matched veneers from Woodcraft supply.The secong photo is bookmatched Camphor veneer.The third photo is Bruce holding a sample of Avodire Crotch veneer, with No Finish on it. Some of you may have noticed my slight addiction to working with veneers. When you start to investigate the available veneers on the market, it becomes very difficult for me to understand the resistance to it that some people have....
Part 2: Flattening Veneers
When using some veneers, they must be flattened prior to use. This is especially true of burls, crotch and stump veneers. Flattening them really isn’t a big problem, it just takes a little time, and a flattening agent. The main steps are to spray the front and backs of the veneers. Once the are sprayed, they are placed between plattens and some sort of absorbent paper. Some people use newspaper, but I ‘m always concerned about print showing up on my veneer. I us...
Part 3: Bath Vanity
Here’s a bathroom vanity we made for a client a number of years ago. I never got back there to get a shot when the wall was finished. It’s made using Curly Maple Veneer over bendy board, and Rosewood. The curves were formed in a vacuum bag over a form, and an air bladder. The finish is conversion varnish. Thanks; Lee
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
Blog Series
- Advice on Patents - 1 part
- BIrds Eye Table Construction - 1 part
- Burls - 1 part
- Conference table / work bench - 2 parts
- Custom Desk - 1 part
- Custom Floor - 1 part
- Demilune table tops - 2 parts
- Elevator Door? - 1 part
- Fine Woodworking & Ezee-Feed Review - 1 part
- Fine Woodworking does ezee-feed review - 2 parts
- Fireplace Mantle - 1 part
- General Posts - non woodworking - 1 part
- Homemade Tools - 3 parts
- Jigs - 2 parts
- Living Room and Bar Project - 1 part
- Marquetry - 1 part
- One year already? - 1 part
- Our Shop - 1 part
- Pizza Ovens - 0 parts
- Proud of my Buddy - 1 part
- Router Table - 1 part
- Router Table Fence - 1 part
- Shop Featured on Delta |PorterCable - 2 parts
- Shop Safety - 3 parts
- Techniques - 1 part
- Vacuum series - 1 part
- Veneering - 3 parts
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
