| Blog series by CutNRun | updated 205 days ago | 3 parts | 701 reads | 18 comments total |
Part 1: Parts and Pieces
Two days before Christmas, my wife casually mentions that she would like a jewelry box. Hmmm, don’t think the timing was very good. Having completed the 2×4 project, I decided to try to put together a jewelry box from the small pieces of wood laying around in my shop. I had a decent amount of 1/2” cherry, some figured maple, some oak, and a small amount of paduk. After spending a few days laying out a design and seeing if I had enough wood, I started cutting and gluing.Th...
Part 2: Measure twice, cut once
I actually measured very carefully three times; the bottom of the dado would be precisely 3 15/16” from the end of the board. I carefully routed all four dadoes, stopping at the right spot. Then I looked as the spacing, relative to the other grooves. What happened? I measured from the end of the board – exactly 3 15/16”. I looked again at my full scale plans and the measurements I had calculated – 3 5/16”! Dooh! Exact comments are deleted to maintain a fam...
Part 3: One more slight adjustment
Well, the jewelry box is assembled and now complete. I assembled everything and did one final trial assembly, including mounting the doors. The hinges were neatly mortised and the doors were perfectly aligned – 1/16” space on all sides. I opened the doors and discovered the drawings behind the doors lacked a shy 1/16” of clearing the hinges. Rats. So… I filled the mortises on the back of the doors and doubled the depth of the mortises in the casing. The doors are...
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
Blog Series
- 2 x 4 Project - 1 part
- Tool cabinet - 8 parts
- Wood Scrap Box - 3 parts
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
