| Blog series by Al Navas | updated 156 days ago | 3 parts | 1836 reads | 13 comments total |
Part 1: The doors
From my blog: This time I show how I made the frame and panel cabinet doors, with emphasis on the simple design elements that enhance their looks. For example, it is desirable to match the grain across the rails – and always keep track of which frame piece goes where ;-) . But the focus is on the bookmatched spalted maple panels. Clamped doors during dry fit, showing the grain continuity in the top rails: .
Part 2: Knife hinges
For the hand tool users: If you have any suggestions on how I could improve my chisel technique to chop the mortises, please let me know ;-) – THANKS! From my blog post: In this episode I show how I did the layout and chopped the mortises for the knife hinges in the doors, and in the carcase. Then, for the first time, I do a dry fit of the frame and panel doors to the carcase. The knife hinges provide an elegant solution in this cabinet, because they are unobtrusive; they remai...
Part 3: Overlapping rabbets to fit the doors
From my blog: In this episode I show how overlapping rabbets provide one solution to fitting the doors to the cabinet, while minimizing the door gap. I used a small shoulder plane to clean up the rabbet surfaces, to improve the fit and allow the doors to close with a nice, tight fit. Credit for the overlapping rabbet solution belongs to Norman Pirollo, who publishes the blog The Refined Edge. Thanks, Norman!
Reserved for special entries.
By subscribing to the RSS feed you will be notified when new entries are posted on this blog.
Blog Series
Your Online Shop - Your Support Is Greatly Appreciated - Your Woodworking Showcase - 3 Ways To Help, Financially - Your Woodworking Community
