wb poly

  • Advertise with us
Blog entry by james posted 03-15-2012 12:07 AM 6645 reads 0 times favorited 3 comments Add to Favorites Watch

Hope everyone is doing well and in good health. So years ago when I was in the wood working field I mainly did refinishing for a company where we used sand sealer and nitrocellulose laq out of a pressure pot system. This was about 15 years ago. Now I’ve been reading with the advances in things that a gravity fed gun and wb work well enough without the expensive shop setup. So does anyone have any experience with this and if so what sprayable poly is out there that would work well?


3 comments so far

View FreshSawDust's profile


68 posts in 2353 days

#1 posted 03-15-2012 12:44 AM

I have had real good luck with General Finishes polyacrylic, not so much with the minwax.

-- TJ - Perryville, Missouri

View stan3443's profile


301 posts in 2299 days

#2 posted 03-15-2012 03:18 AM

have only used minwax but was very happy with it on a small production run of 50 frames

-- If your not supposed to have hair on your face......why does it grow their

View Bigrock's profile


292 posts in 2986 days

#3 posted 03-15-2012 08:19 PM

I think at this time General Finishes is the way to go. Both there Polyacrylic and there Endro are very good. These finishes are not cheap. If you check with Charles Neil he has a lot of tips on using water base finishes. It has a lot to do with the needle and going down to about a 1.5 to get the spray smooth. Have Fun

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics