LumberJocks

need help

  • Advertise with us
Blog entry by jim1953 posted 09-10-2008 04:21 AM 1035 reads 0 times favorited 4 comments Add to Favorites Watch

Hi,
Has anyone ever made a jig for raised panel doors using a table saw? I am re-modeling the kitchen cabinets and want to make raised panel doors.
Any ideas?

-- Jim, Kentucky



4 comments so far

View tooldad's profile

tooldad

660 posts in 3179 days


#1 posted 09-10-2008 05:16 AM

I have not personally, but there are plenty of LJ’s who have and maybe can send you a pic. Basically make a u-shaped sled that goes over your fence with the blade side board being at least a foot tall and 12-18” wide. Set the angle of your blade at the desired angle, about 15deg, clamp board to the jig and slide through. Sorry I haven’t made one because I use a shaper. Hope this helps some.

View SteveKorz's profile

SteveKorz

2134 posts in 3178 days


#2 posted 09-10-2008 07:15 AM

Try this
or maybe this
... or this
(another one)
... last but not least…. always try google .. lol.

Good luck.
—Steve

-- As iron sharpens iron, so one man sharpens another. (Proverbs 27:17) †

View corgifrog's profile

corgifrog

4 posts in 3015 days


#3 posted 09-10-2008 07:52 PM

well, I have done this a time or 3. i made a jig that I attached to the tablesaw and ran the wood across the saw blade at an angle. it is better to take very small increments, so you dont get kickback. i had to make some “barn doors” and the taper that was way too big for a shaper was also a cope. draw it out first, then figure your angle and taper if necessary, then try some srap to see if you are getting where you want to be. it is amazing what you can figure out, just remember to be careful, and respect the cutting device!!!
Fine Woodworking #173 has a short article
here are some links…
http://www.superwoodworks.com/Projects/TableSawJig.htm
http://www.newwoodworker.com/pnlrasjig.html
http://www.architectureweek.com/2002/0417/building_1-2.html

hope this helps, but once you start makin jigs, you will lose shelf space fast… kidding

View Bill Akins's profile

Bill Akins

425 posts in 3162 days


#4 posted 10-03-2008 01:58 PM

Check my site out. I made a cedar chest with raised panels on the table saw this summer. Under all projects, you see how I did it. They turned out great. Looking forward to your finished project.

-- Bill from Lithia Springs, GA I love the smell of sawdust in the morning.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com