LumberJocks

Church pews project #10: butchers block in clamps and ding table in situ

  • Advertise with us
Blog entry by inchanga posted 02-07-2013 07:00 PM 1459 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 9: completed farmhouse table and start on butchers block Part 10 of Church pews project series Part 11: Butchers block finished startin monks bench »

The dining table has been deliveredn and is shown in its final resting place.

Salvaging enough timber to make the butchers block top has been a nightmare. The maximum thickness of the pieces i finished up using was only just over an inch which came down to just less than an inch after machining the faces. The maximum width of the pieces was only 3 inches. This meant I had to assemble and glue three times as many bits of wood as i would normally use on a top this size.

It cost a fortune in glue…..


When the glue is dry I will machine it square, sand the top smooth and put a timber border all around it.

-- chris, north wales http://salemchapelfurniture.co.uk/



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase