LumberJocks

Marking Gauge #2: wear strips

  • Advertise with us
Blog entry by harum posted 07-24-2014 08:14 PM 1279 reads 1 time favorited 0 comments Add to Favorites Watch
« Part 1: have finally started Part 2 of Marking Gauge series Part 3: some progress »

Cut and sanded the strips to the right width, and cleaned the exposed sides with grit 320 sand paper.

Have to find a piece of 5/16” brass rod or a couple of bolts for the shoes and come up with a way to cut a thin slit through the beam to hold cutter blades. This slit will be at the bottom of a hole at one of the ends of the beam.

-- "If you're not counting the ripples when throwing pebbles in the water, you're wasting your time."



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com