greg48's Blog

  • Advertise with us
This blog is written by greg48 | 20 entries so far

Latest Entry

Cabinet Conversion (pc:Repurposing) #3: Finishing up

10-07-2015 03:46 PM by greg48 | 0 comments »

Started up again after returning from the Reno Air Races by jointing the edges of some 3/4” Beech boards and dowel/gluing them up into wider boards for the cocktail box and vertical divider. The cocktail box front and floor were joined using a 1/4” tongue and groove then screwed into the sides and back with pocket hole screws from beneath. The wine rack was next on the list. I cut 1 1/4” and 3 1/4” holes in the center of 4” wide 3/4” Beech stock then ripped them into 2” wide pieces each with 1/2 circle arcs to hold the wine bottles. Powering the 3 1/4” Forstner bit with my single belted Shop Smith was about the limit of the machine without dogging the bit and spinning the drive belt...

Read this entry »

Older Entries

View all 20 entries »

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics