Power Tools, Hardware and Accessories Forum

  • Advertise with us

Are you unsure of which tools, or hardware, you need, or which brands to buy? Investing in tools and hardware can be an overwhelming adventure, and you have some tough decisions to make. Welcome to the Woodworking Forum that allows you to seek and find essential information from other like-minded folks who have walked the same path before.

Topics Replies Last post
View Estley's profile

Earlex 5500

03-24-2012 07:04 PM by Estley

So I’ve decided to take the plunge into an HVLP system, and for my budg...

1 03-25-2012 05:45 PM
View WOODIE1's profile

Help with new miter saw?

03-25-2012 05:48 AM by WOODIE1

I bought Makita 7” sliding miter saw to have a easily portable saw. Lu...

3 03-25-2012 08:31 AM
View cutworm's profile

Router slipping out of base

03-22-2012 01:21 AM by cutworm

I have a Ridgid combo router and have the fixed base installed on a table. T...

5 03-25-2012 05:42 AM
View rance's profile

Festool-Domino Jointer

03-24-2012 05:09 AM by rance

I am using a good friend’s Domino jointer and have some questions. The ...

6 03-25-2012 05:37 AM
View Tig1242's profile

bandsaw broken - tracking issues

03-16-2012 04:27 PM by Tig1242

I have an older delta bandsaw 14” model 28-243 It has been working g...

5 03-25-2012 03:52 AM
View Peter5's profile

template routering pin technique?

03-23-2012 06:44 PM by Peter5

I trace a lot of templates with my router as I’m sure most of you do as...

5 03-25-2012 03:25 AM
View seabiscuit's profile

Table Saw decision advice

03-24-2012 10:54 PM by seabiscuit

This is from a phone so bare with me. Which of these two would you buy? Rockw...

10 03-25-2012 02:37 AM
View Joekwon80's profile

Delta Dust Collector 240v Wiring?

03-24-2012 01:10 AM by Joekwon80

I have found how to wire it. But my question is what kind of plug do I need a...

26 03-24-2012 08:03 PM
View TheRock's profile

DIY Panel SAw

03-23-2012 02:42 PM by TheRock

I need to remodel my wife’s kitchen (or get a new wife, and that is no ...

21 03-24-2012 07:22 PM
View Mike's profile

DEWALT DWS520CK TrackSaw Kit with 59-Inch and 102-Inch Track

03-24-2012 06:16 PM by Mike

Small parts dot com has dws520ck for 371.03 free next day shipping. Any one w...

0 03-24-2012 06:16 PM
View BlankMan's profile

Laguna Mobile Cyclone

03-24-2012 04:12 PM by BlankMan

Happened to stop at the Rockler store during the week to drop off some blades...

2 03-24-2012 05:55 PM
View justholler's profile

Vendors at a woodworking show?

03-24-2012 01:27 PM by justholler

I’ll make this short and sweet….can I buy a Grizzly table saw at ...

2 03-24-2012 02:19 PM
View Peter5's profile

Do any of you use Bose noise-cancelling headphones?

03-19-2012 07:11 PM by Peter5

I’ve been wanting to figure out a way to listen to music and/or the rad...

28 03-24-2012 01:09 PM
View Martyroc's profile

Low cost easy setup jointer

03-18-2012 08:45 PM by Martyroc

Hello fellow Lumberjocks,I need to replace my jointer eventually, hopefully s...

7 03-24-2012 10:39 AM
View RinnyTin's profile

closet door hardware

03-09-2012 04:02 PM by RinnyTin

Am working on finishing the attic, and have 4 closets under the eaves tha...

1 03-24-2012 04:40 AM
View Cozmo35's profile

Jointer Blades

03-23-2012 11:25 PM by Cozmo35

Hey Y’all, I am a bit of a quandary. I have a 1930’s model “Boise Crane” joi...

5 03-24-2012 02:34 AM
View Adrian A's profile

Festool 106" guide rail. Why God Why

03-23-2012 09:46 PM by Adrian A

I can deal with paying for $550 for the TS 55 saw and 55” track, but an...

7 03-24-2012 01:51 AM
View ,'s profile

Advice needed on speed air compressor on cl

03-22-2012 03:15 AM by ,

Our current greatest shop need is the air compressor. We have mostly used po...

9 03-24-2012 12:13 AM
View cdhilburn's profile

R4511 or Jet JTAS-10 Questions

03-09-2012 02:47 PM by cdhilburn

I have finally given up on my Craftsman 21833 because the dang alignment is n...

64 03-23-2012 11:33 PM
View TDog77's profile

Delta 13 inch planer $700 what ya think.

03-23-2012 05:10 PM by TDog77 At this point totally non...

2 03-23-2012 06:34 PM

« prev 1 ... 783 784 785 786 787 788 789 ... 1330 next »
26589 topics

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics