LumberJocks

fatandy2003's Blog

  • Advertise with us
This blog is written by fatandy2003 | 4 entries so far

Latest Entry

A Tale of Two Guitars #4: Truss Rod Channel and Tenon

03-07-2016 06:29 AM by fatandy2003 | 2 comments »

Alright, it’s been a while since I posted. Here is the neck after the scarf joint and heel block have been glued up and then cleaned up with a block plane. Everything needs to be squared up at this point in order to get a good (clean) routed channel for the truss rod. I didn’t take a picture while routing the channel, well, because you all know how a router table works… and I was a little busy keeping my fingers away from the spinning bit. But, basically, you mark the center of the neck blank, then set up your router table to take an equal amount of material from each side of center. It is best to choose a bit that is big enough for the truss rod to fit snugly into the channel...

Read this entry »

Older Entries


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com