The only major defect is c hip missing from the top of the tote. I was going to pass on repairing the tote mainly because there was no way I could duplicate the wood, and I really wanted a clear finish on the tote and knob. However the top of the ...
|View dschlic1's:||home||workshop||projects (8)||blog (7)||reviews (2)||forum topics (17)||buddies (0)||favorites (0)||activity log|
None so far
149 posts in 574 days
Location: Valrico, FL
Latest Activity | view all »
|replied on||Best lumber for a patio cart||34 days ago|
|replied on||Best lumber for a patio cart||41 days ago|
|started topic||Best lumber for a patio cart||41 days ago|
|commented on||Craftsman Table Saw 113.298240 Completed||69 days ago|
|started topic||Experiences with shop built router lifts||74 days ago|
|added project||Prayer table for my wonderful wife||81 days ago|
|commented on||My hand plane journey #2: Initial cleaning||115 days ago|
|added blog entry||My hand plane journey #3: Repairs||115 days ago|
|commented on||My hand plane journey #1: The aquisition||116 days ago|
|added blog entry||My hand plane journey #2: Initial cleaning||116 days ago|
|added blog entry||My hand plane journey #1: The aquisition||117 days ago|
|commented on||ZCI Inserts #1: MDF and Garolite||127 days ago|
|commented on||Best used Tool I ever purchased||135 days ago|
|started topic||Planer sled questions||160 days ago|
|commented on||The "I'm Not Worthy" Project Log #6: Zero Clearance.... Not NSA Approved!!!||178 days ago|
Latest Projects | view all 8 »
Latest Blog Entries | view all 7 »
The next step on my hand plane journey is to disassemble all the parts and clean everything up. I separated all of the ferrous metal parts and put them in a bath of Evapo-rust: I also sanded off the finish on the knob and tote. The tote has a c...
I am writing this blog to describe my journey down the bench plane path. I hope that it does not bore everyone. I have a small shop in my two car garage which has two cars it in. In other words very cramped, but I have a niche in which I store my ...
Finally had time to start cutting the parts for the stand. Here is a photo of all of the pieces cut: I used a Dremel tool to cut the disks. Rather than buy the plastics disks from Work Sharp, I made some disks from hardboard and also from MDF. ...
Over the weekend I scored a Work Sharp 2000 off of Craig’s List. $40 for a new in the box unit. Using the included abrasives, I put a fairly good edge on my chisels and plane. I quickly saw the need to go to finer grades of abrasives. I also...