$50 24" Grizzly drum sander #6: Finally Getting closer to done!

  • Advertise with us
Blog entry by drfixit posted 11-14-2010 02:14 AM 1572 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 5: The Purple Monster is getting closer! Part 6 of $50 24" Grizzly drum sander series no next part

Well no that it has cooled down I can get back out in the shop and back to work! Got a 1-1/2 horsepower motor to run the drums, got a replacement chain for the conveor belt. Would like to have replaced the conveor belt to, but money is too tight for now. I wired it all up today and noticed that the rear drum seems to be slightly out of round on one end. So now i need to figure out what is wrong there, then built the top and dust port.

-- I GIVE UP!!!! I've cut this @!&*!% board 3 times.... its still too short!

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics