LumberJocks

A new kitchen table #2: And then there were four

  • Advertise with us
Blog entry by derosa posted 05-21-2011 05:54 AM 4884 reads 0 times favorited 1 comment Add to Favorites Watch
« Part 1: preparing the top Part 2 of A new kitchen table series Part 3: And curved breadboard ends »

Finally managed to get the fourth board jointed (the board on the left), as you can see from the pic this one had some tough grain to work with. The board was bowed up about 1/8” in the center, the grain runs in two different directions and the top end has the start of a very large knot that gave the plane a lot of trouble. I’ll send them all through the planer tomorrow, the shop shares a wall with the bedroom and the wife is sleeping so it’ll have to wait till then; after which I can start jointing the sides to get then ready for fitting together.

-- --Rev. Russ in NY-- A posse ad esse



1 comment so far

View Mark Shymanski's profile

Mark Shymanski

5113 posts in 2378 days


#1 posted 06-10-2011 04:48 AM

That sure does look like difficult grain to run through a planer.

-- "Checking for square? What madness is this! The cabinet is square because I will it to be so!" Jeremy Greiner LJ Topic#20953 2011 Feb 2

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase