LumberJocks

deejay34's Blog

  • Advertise with us
This blog is written by deejay34 | 7 entries so far

Latest Entry

Jounter Vibration & Noise Issue

04-27-2018 11:26 AM by deejay34 | 8 comments »

I’m in the process of finishing an overhaul (tear down, clean up, paint, and reassemble) of a Invicta/Delta DJ-15 6” jointer (blog series can be found here). Part of this process involved installing new bearings (NTN 6004LLBC3/EM) in the cutterhead (no new bearings in the motor), a Fenner Drives PowerTwist link belt, and a cast iron motor pulley (Amec AK71X5/8). I should note that I do not own a press, so I used a pipe sized to the outer bearing race diameter to press the bearings into the bearing blocks, and another pipe sized to the inner bearing race diameter to press the bearings onto the cutterhead shaft. Everything seemed to go ok there. Upon completing reassembly, I ...

Read this entry »

Older Entries


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com