Did I come up with a new idea

  • Advertise with us
Blog entry by cutmantom posted 12-31-2016 05:14 PM 499 reads 0 times favorited 0 comments Add to Favorites Watch

I needed to drill into the end of a workpiece for a dowel but didn’t want to tilt my drill press table to do it, I have a drill guide so it can’t to me that if I clamp the piece in the vise flush with the top and square to the top I could use the guide and drill straight down

The blocks were used because the vise is slightly lower than the bench top

0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics