01-18-2012 06:27 AM
by CartersWhittling |
33 comments »
Hello.
I have finally put out the second installment of the tutorial. I had to break up the video into two sections in order to fit it onto youtube.
In this part I begin work on the tap by making the guide block my friend Chris Legendre designed. The lumber you want to use for the guide should be a hardwood at least 2” thick. Depending on the size of screw you will be making the block can be 3” – 6” wide. It only needs to be surface on one face and one edge. Then...
Read this entry »
03-24-2012 04:10 PM
by BritBoxmaker |
20 comments »
To life the Universe and everything. As all you readers of Douglas Adams’ Hitch-Hikers’s Guide to the Galaxy will know.
For me it is, as well as that, a quest for yet smaller wooden hinges. Don’t Panic (as the Guide says on it’s cover, in big, friendly, letters) I am prepared to fail on this one. This (lid removed for clarity) is what I am planning to achieve
A, cubic, reversible box with sides that are 42mm long and high by 3mm thick (1.65” by just und...
Read this entry »
03-22-2012 06:54 AM
by Marty Backe |
23 comments »
Shelving, drawer fronts, utility cabinet tops. These are typical items that get built with plywood or other sheet goods such as melamine. The convenience of using sheet goods is great, but one downside is that quite often one or more of the edges must be covered. In this post I explain the process that I follow to apply hardwood edging to sheet goods. In this case I am covering the edges of melamine drawer fronts with poplar.
This video shows me going through the process described here...
Read this entry »
01-11-2012 12:13 AM
by Brit |
21 comments »
I decided to dedicate my time this winter to restoring various saws I’ve acquired over the past year. I’ll be restoring half-rip saws, panel saws, tenon saws, carcass saws and dovetail saws from a variety of makers, dating from the 1840s up to the 1960s. Now don’t worry I’m not going to bore you with repetitive photos of me removing rust, shining saw plates, polishing brass and refinishing totes. I covered the process I use for these steps in my blog The Restoration of a 14” Tenon Saw so you ...
Read this entry »