Project Information
I got this idea from Fine Wood Working, I think. Here is what it dose, it give you a clean cut from your mite saw.
The Project is two pieces of Hard Board you will have to form a back & a bottom ( for you saw ). Then you cut these pieces with the saw to form the "slot" for you saw. Now the Back & Bottom of the pieces get put on a bigger bottom piece used double sided tape to keep them moving around.
The bigger piece on the bottom will give the support whole to the jig. I all use a pin nailer in key spots to keep thing from moving around.
The Project is two pieces of Hard Board you will have to form a back & a bottom ( for you saw ). Then you cut these pieces with the saw to form the "slot" for you saw. Now the Back & Bottom of the pieces get put on a bigger bottom piece used double sided tape to keep them moving around.
The bigger piece on the bottom will give the support whole to the jig. I all use a pin nailer in key spots to keep thing from moving around.