Grizzly - G0513X2 17" Bandsaw 2HP w/Cast Iron Trunnion (Rating: 5)

Well I finished putting it together yeaterday and tunning it up. It went quite well. I did use the stock blade first. Figured might as well use it for a bit. I put the 1" on it a timberwolf. My first cut was on a small 2×4 to check things for alignment. So for the big test. I took a piece of oak 2×6. I took a 1/2 off of it measured it great cut. Took that piece down to 1/4", still a good cut. Then took it a little farther took that piece down to 1/16" Same great cut. Now I just need to figure where to put into my shop. I will post pic's of the new arrangment of the shop when I get it done. Thanks again for all the info that you gave me to make this purchase.
Tim: