Project Information
I worked very diligently this weekend to finish the router table top. I added the formica veneer to the substrate, trimmed it. White veneer for the top and a dark veneer for the bottom. I did this so I would know which side is up! Just kidding-I needed the rest of the 4×8 white formica for another project so I used a different piece of veneer for the bottom.
Added dadoes for the t-tracks. Cut out the hole for the router table insert. Used a 1/8" round-over bit for the top edges.
Writing it down doesn't seem like it should've taken so much of my time. I will post the process and additional pictures in my router table series sometime this week.
Added dadoes for the t-tracks. Cut out the hole for the router table insert. Used a 1/8" round-over bit for the top edges.
Writing it down doesn't seem like it should've taken so much of my time. I will post the process and additional pictures in my router table series sometime this week.