LumberJocks Woodworking Forum banner

Comments

· Registered
Joined
·
156 Posts
Nice work, expect this idea to be stolen by many people, first of all me :)
 

· Registered
Joined
·
9 Posts
me third. nice work.
 

· Registered
Joined
·
62 Posts
LOL, have at it. If there were provisions to upload plans and cutlists here, I would. I'm too afraid of screwing up not to draft nearly everything in sketchup, and then assemble it in 3d to make sure I didn't have any brain farts. This on the other hand was about fifteen minutes of sheer pleasure while I played with the donated wobble dado.
 

· Registered
Joined
·
50 Posts
Click! Added to my favorites…...very nice idea.
Thanks for sharing.
Well done.
 

· Registered
Joined
·
107 Posts
very nice. I did similar device only used 2 = 1/4" dowels, 7" long per lid.
 

Attachments

· Registered
Joined
·
2,000 Posts
I like your solution..I have the same problem. I am going to install pull outs and thanks to the previous post, now I know how the do the upper draw to hold the lids! Thanks
 

· Registered
Joined
·
122 Posts
Damn!My wife saw that!Now I have to make one.
 

· Registered
Joined
·
274 Posts
Hmmmm best not show the other half this… lol
 

· Registered
Joined
·
62 Posts
Oh, just wait until she takes a snappy and shows it to her girlfriends…

But hey, if you don't have a dado blade, it's a good excuse for her to buy you one!
 
Top