Woodworking blog entries tagged with 'wall hung'

  • Advertise with us
View A Slice of Wood Workshop's profile

Wall Hung Tool Cabinet

02-01-2014 02:57 PM by A Slice of Wood Workshop | 0 comments »

Made this tool chest to hold some of my hand tools and marking tools. This was very simple and made from 1 sheet of 3/4” plywood. Check out the video here. As always, please share and subscribe!

Read this entry »

View Smitty_Cabinetshop's profile

Wall Hung Tool Cabinet #1: This is going to happen, right?

03-19-2012 03:35 AM by Smitty_Cabinetshop | 18 comments »

EDIT: Updated pic links to ditch PB-BS. At one point in another forum post here on LJs, I offered a tool cabinet would be worked using the raw materials salvaged from this old Hoosier cabinet topper. Including the beat up piece of tambour door. Some fine grit ROS work on the tambouR got it to look presentable; here it is sitting on top of the now-disassembled topper. Not sure where this is headed, evidenced by the foot-dragging on the project so far. But, I did bui...

Read this entry »

View Byron's profile

Work In Progress #5: Canasta Final Part

11-22-2011 07:31 PM by Byron | 2 comments »

So heres the finished thing. You can see it open in the pictures on the bottom. Better pictures soon to come. The drawers are an important part of my design because of my mother. When I was younger she taught my older brother and myself how to play canasta, and always had two nice decks of cards to play, unfortunately we were not the cleanest while playing and the cards almost always got ruined. Eventually she started to hide the cards. It came to the point where she would burry the c...

Read this entry »

View captkerk's profile

Wall Hung Console #12: It's assembled

10-29-2009 11:19 PM by captkerk | 4 comments »

It’s finally assembled. I started today by fitting the curved braces that connect the center bracket to the two end brackets. After quite a few trips to the miter saw to shave off “just a hair,” I finally had snug butt joints and evened-up braces. The problem was that the 3/4” braces were butting up against the 3/4” bracket-backer boards which already had a 1/8” round-over on them. This wouldn’t do. The fix was to run the curved braces throug...

Read this entry »

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics