11-05-2010 12:33 AM
by nobuckle |
10 comments »
Today I started working on a router table idea that I came up with. I currently have a router table (more like a cabinet really) but it takes up to much room in my shop. If you’ve read my profile you know that I only have 99 sq. ft. of main shop space, so maximizing space is a constant challenge. I’ve decided to move the left-hand table saw extension of my table saw to the right side and replace it with some material that could be used for a router table. The material I select...
Read this entry »
01-18-2014 09:59 PM
by hjt |
2 comments »
In the process of building the base, I did what I do best… I screwed up. This time the screw up was adding incorrectly. After a little discussion with my fellow LJ’s, I decided to cut more lumber and start over.
I ran a bunch of lumber through the planner. While I have this connected to my dust collector, I’m amazed how much shavings still end up on the floor.
I felt half laps would provide me the best strength and support for this project, especially since the planer and drill w...
Read this entry »
08-01-2014 05:19 PM
by harum |
0 comments »
Haven’t had much time lately for my marking gauge: our neighbor pulled out of her garage on her SUV without … opening the garage door. Fixing the door has taken more than I thought it would.
Epoxied brass wear strip, the fence and put in the threaded insert. Instead of the suggested 3/8” hole for the insert I had to make it a bit wider than 7/16”—the rosewood’s really hard. Found a brass bolt to be sacrificed for two shoes.
The knurled scr...
Read this entry »