This post will show you the way I finish the boards. I will not be painting these yet but I have included a link at the bottom for customization help. I just want to show you how to build the boards and prepare them for paint or stain. The first step in finishing the boards is flush trimming the plywood to the frame. If you don’t have a flush trim bit, you can just sand it down if it’s not too far off. I also like to adjust my flush bit to smooth out the inside of the hole....
Cut the last 4 foot piece three times. Cut two one foot legs first, then measure and cut the top piece. It should be about 22.5” or so. Put the legs in the leg slot. Make sure to leave enough room for the legs to slide in and out even after they are painted. Predrill, countersink and screw two screws per side. These are the legs. I find that it’s best to simply sand down the edges instead of using a round over router bit. I’ll cover sanding and routing i...
The next step is cutting and installing the sides of the frame. This method includes building the frame to the top instead of building a frame then adding the top. It makes for perfectly smooth sides. The link to these pictures is not working but here is a link to the entire gallery. This is a great way to see all the pictures in one place. Cornhole Tutorial Measure the length of your boards, some boards cut by big box stores aren’t perfectly 48” and therefore you may ne...
In this section I’m going to cover the tools and materials needed and the first step in making the boards. Here are a few examples of boards I’ve built. If you’ve never played cornhole before, it’s essentially horseshoes. You toss bean bags on to the boards and you get three points for making it in the hole, and one point for making it on the board. You play in teams and throw against the other team. I’ll include rules in the last post. Tools: Power DrillPower DriverJig Saw or ...
To save my back the next time I luck into some huge logs, I found and purchased some Highland Ramparts brackets from Pep Boys, while there replacing my new truck’s dead battery. I’ve seen gardeners in the area loading and unloading rider lawnmowers and everything else with these things, so me and a log on a hand truck should be fine, despite my ample size. I also picked up the required 2×8s, each 8’ long. Unfortunately, measuring my truck’s unfolded tailgate he...
- My Journey As A Creative Designer - Woodworking and Beyond - 1742 parts
- Extremely Average - 324 parts
- Workshop Development - 107 parts
- A journey into the workshop. - 105 parts
- Just for Fun... - 97 parts
- Daily Update - 87 parts
- Life as an Amateur Woodworker - 79 parts
- "Hobbit Holes in MyWorld" --by RusticWoodArt - 77 parts
- As The Lathe Turns - 76 parts
- WoodWriting Haiku Thursday's --by RusticWoodArt - 74 parts
- Sheila Landry (scrollgirl) - 1767 entries
- dbhost - 418 entries
- frank - 417 entries
- degoose - 397 entries
- Ecocandle - 325 entries
- MsDebbieP - 314 entries
- Karson - 305 entries
- mafe - 304 entries
- Martin Sojka - 296 entries
- William - 258 entries
- shipwright - 246 entries
- Betsy - 228 entries
- stefang - 220 entries
- robscastle - 218 entries
- Dave Rutan - 213 entries
- Stevinmarin - 212 entries
- Todd A. Clippinger - 207 entries
- Gary Fixler - 204 entries
- Smitty_Cabinetshop - 193 entries
- A Slice of Wood Workshop - 190 entries