Woodworking blog entries tagged with 'tablesaw base'

  • Advertise with us
View Craftsman on the lake's profile

Five years later, Workshop Remodel. Going from pretty to functional #3: Table saw base

01-29-2014 07:49 PM by Craftsman on the lake | 7 comments »

In my quest to redo the shop better after 5 years of beating it up. Heated the shop for a short while today. I took my old delta/rockwell 10” table saw off the metal legs and put it on this base I made today. The locking wheels on the other base made the saw too high. I brought this one low, the same height as a bench would be for me, 34”. The outfeed/assembly table I’ll make next will be the same height. So will the new movable miter saw table. Everkthing is made of 3/4&...

Read this entry »

View Tugboater78's profile

shop jigs/furniture/fixtures #3: table saw base #1

10-22-2013 07:29 AM by Tugboater78 | 1 comment »

I need my saw to be able to move and the factory base isn’t exactly made for such. I took some ideas from some Youtube videos and decided to jump in and make a one for my Craftsman contractor saw. the videos:Laney ShaughnessyEd Rivera i was a pocket holing fool starting some assembly it’s sitting about 36” above where it will be going….

Read this entry »

View WoodJediNTraining's profile

Building a Tablesaw Base Part 2

04-22-2013 12:12 AM by WoodJediNTraining | 4 comments »

Well I finally finished the Tablesaw Base, trying to film during rain storms is almost impossible with the ambient noise from the rain hitting the metal roof.. but I waited it out, and am very happy with the outcome.. Here is a look at the final steps of building this base

Read this entry »

View WoodJediNTraining's profile

Building a Tablesaw Base Part 1

04-11-2013 12:15 AM by WoodJediNTraining | 13 comments »

Recently I had a need to build a new table saw base for my saw. Rather than just building a simple replacement base, I opted to build one with lots of storage potential. This new base measures 6 feet long by 2 feet wide, which gave me good reason to move over to the new shop building. I haven’t yet finished the new shop set up ( haven’t even started) but this build is a great start giving me lots of options for storage potential… This build is a 2 part project. So be sure to...

Read this entry »

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics